|
Pre-Spray Extraction
Cleaning
Pre-spray the carpet well with
the Red (Heavy Duty)
or
Carpet Complete
(10oz/Gallon) solution from the pressure sprayer,
let sit
for ten minutes and extract with clean water. (Make sure all other
shampoo products are rinsed
free from the extractor solution tank,
contamination with other products will dramatically decrease the
effectiveness of
H2Orange2.)
Serious stains should be
sprayed with Red (Heavy Duty)
or
Carpet
Complete
(10oz/Gallon) solution before the general pre-spray. The
pre-spray
method makes the most of H2Orange2
cleaning effectiveness and leaves the carpet free of residue
after clean water
extraction.
Carpet Complete
can be used directly into extractors at 2oz per gallon without leaving
any residue on the carpet. Once the carpet is dry just vacuum any residual
material left
on the carpet.
Bonnet Cleaning
Use
Red (Heavy Duty) solution
or Carpet Complete 10 oz. per gallon.
(Optional: Rinse
with Extractor afterwards.)
Dry with air mover.
Spot Cleaning
For most spots the
Red (Heavy Duty), Quick Spot RTU or
Carpet Complete (10oz/Gallon)
is the best choice in spot cleaning. Spray the spot and let sit for five to
ten minutes,
then scrub or blot soil away and some spots just disappear. Even though the
Red (Heavy Duty) will not leave a lot of residue it still must be
rinsed to avoid collection of
soils from foot
traffic. The
Green solution can be used as a rinse if a
portable extractor
is not available. If the above fail try Ultimate or
Quick Spot RTU or Carpet Complete Concentrate.
For grease spots use The Greasinator.
|
